Floor Mount Stanchion



Related Documents:
Spec/Diagram PDF

Item Information:

One piece Floor Stand with square or round tube cut to specified length. One end of the tube has a capped end with a rod hole. The rod hole is used for telescopic adjustment of the hanger rod. The open end of the tube is welded to a base plate which can be supplied with anchor bolt holes. Specify the steel finish and the finish on the weld.

Features: Hole in capped end of tube allows the hanger rod to be manually adjusted for telescopic location of the tube or pipe.
Hardware: 304 stainless steel: 316 stainless steel, carbon steel & zinc plated carbon steel
Finish: Mill = Fabricated steel and welds are a mill finish
Buff = Fabricated steel and welds are buffed to remove splatter
BLND = Fabricated steel is polished and welds are blended
Special finishes and painted stanchions are available, call Behringer


Note: If using Dynamic housing as a sliding base support, it is recommended to tack weld the housing once slope has been verified. This will ensure that the base plate remains flat or parallel to the resting surface. This particularly applies to high temperature service lines that will experience thermal cycling.